When you first start the SIM-board Control Center program, you will be presented with the following screen:

To begin a new project you should have the software auto-detect the boards in your stack.
To do this:

• Switch on the power switch of your master SIM-board.
• Click the Auto-detect button.

After a short while, the boards that are found will be listed in the auto-detect window:

If the list is shown correctly, click on the "Create project with these boards" button to begin your project.

If the list is incorrect, switch off your master SIM-board power switch to remove power from the boards, ensure all the ribbon cable connections between the boards are correctly located and firmly pushed secure in place on the pins, and then click the "Refresh" button to try again.

Click "Next" to continue...